Natural Kaveri Henna for Tattoos in a Cone, 25 g

Natural henna for tattoos in a practical cone

Kaveri tattoo henna is intended for creating temporary brown designs and henna freckles on the skin. The ready-to-use henna tattoo paste is applied directly from the cone, so no separate applicator is required.

Key features

• Natural body henna: suitable for creating temporary designs and henna tattoos.
• Ready-to-use paste in a cone: applied directly through the fine applicator tip.
• Brown result: the shade develops gradually after the dried paste is removed.
• Pack size: 1 cone weighing 25 g.
• Temporary effect: the finished design may remain visible on the skin for approximately up to one week.

Henna for freckles

Kaveri henna can also be used to create temporary henna freckles. Apply small dots directly from the cone to clean, dry skin. Vary their size and spacing to create an irregular, natural-looking freckle effect.

When applying the product to the face, avoid the immediate eye area. Do not use the product to tint eyebrows or eyelashes, and always perform a patch test on a small area of skin before use.

How to create a henna tattoo

1. Cleanse the skin to remove oil and dry it thoroughly before application.
2. Open the cone by pulling the plastic stopper out of the tip.
3. Gently squeeze the cone and draw the desired design or individual dots directly onto the skin.
4. Allow the applied paste to dry. Drying may take up to one hour.
5. Carefully scrape the dried paste off the skin.

How the brown shade develops

After the dried paste is removed, the design or dots may initially appear lighter. The brown colour will continue to deepen, and the final shade may take up to 24 hours to develop fully.

Henna paste ingredients

Ingredients: Aqua, Lawsonia Inermis (Henna) Leaf Powder, Benzyl Alcohol, Terpineol, Eugenia Caryophyllus (Clove) Bud Oil, Eucalyptus Globulus Leaf Oil.

Storage

Keep away from heat sources and protect from direct sunlight. Keep out of reach of children.

Warnings and patch test

Do not use to tint eyelashes or eyebrows due to their proximity to the eyes and mucous membranes. Do not apply to broken, irritated or abraded skin.

Perform a patch test on a small area of skin before use. Apply a small amount of paste to the palm and allow it to dry. Then wash it off with water and monitor the tested area for 24 hours. Do not use the product if irritation, inflammation, swelling or any other adverse reaction appears on or around the tested area.